fake charging solution is here.Charge shows but never stored.No need to change tahvo ic just connect a 3.6 volt zenor diod between battery connector + and chargingconnector+. Output will be +.
edtmjeBlog
Tuesday, May 24, 2016
2330c No Signal and Auto-ShutOff [Hardware]
Unit: 2330c
Fault: No Signal & Auto-Shut Off
Cause: Wet Unit
Solution for No Signal: Reht UEM
Solution for Auto-Shut Off: Apply Auto-Shut Off Jumper Solution
Finished:
Fault: No Signal & Auto-Shut Off
Cause: Wet Unit
Solution for No Signal: Reht UEM
Solution for Auto-Shut Off: Apply Auto-Shut Off Jumper Solution
Finished:
C3303k No Light IN L solution
1st move...cln the board by magic thinner..still the same!
2nd move... replace l..still the same!
kaya hanap na ako ng solution dito, papalitan ang coil...
may mga solution na nakapost dito pero wla screen shot kung saan nakuha ang pyesa na ipinalit, wla din ako same board para makunan ng coil na pamalit kaya isip mode muna...may mga china phone akong board na stock pero wla kaparehas na coil...dahil sa wala ako maipalit na coil, eto sinubukan ko, coil ng 1110i...
then jumper ko nalang kasi malaki sya compare sa orig na coil...
pagkatapos eto na assemble ko na, sasabit ang cover kaya eto medyo inangat ko..
pagkatapos eto na finish product...
Subscribe to:
Posts (Atom)